Vestil Double Storage Unit Assembly Instructions

Install joint, 2" x 4"s, to 9 foot side of each wooden floor, 3/4" down from top using 6pc - 3" long wood screws, as evenly spaced as possible per side.

Step 3

Using 20pc of 2" long wood screws fasten down the spacer strips directly over the 2" x 4" joints. Evenly space wood screws along entire length of spacer strip.

Step 5

Begin assembly with wooden floors on clean level surface.

Step 7

Secure back wall to the wooden floor using 1/4" x 2" lag bolts into the 5 predrilled holes. Continue holding back wall until at least two walls are connected together and lagged to the wooden floor.

Step 9

Install one side wall by inserting into the lockstrip just installed on the back wall vertical end.

Step 11

Secure both side walls to the wooden floor using 1/4" x 2" lag bolts into the 5 predrilled holes on each side.

Step 13

Insert fill Side Fill Panel into lockstrip and add lockstrip to other Side Fill Panel. Repeat this step for other side of storage unit.

Step 15

Install lockstrips (2) on each side wall, then insert front wall into lockstrips. Install 5pc of 1/4" x 2" lag bolts into predrilled holes to secure front wall to the wooden floor.

Step 17

Install Ridge Cap by inserting center rib between two roof panels.

Step 19

Secure roof to front and back walls with 16pc 1" long self-tapping screws (4pc per wall). These holes are not predrilled. Space screws evenly.

Step 20b

Install hinges on front wall using threaded plats. Threaded plate must be located inside slot. Install 4pc 5/16" nuts onto ends of 5/16" x 1" hex head bolts. Two bolts and nuts per hinge. Nuts not shown.

Step 20d

Install locking bar. Use 6pc of 1/4" x 1" carriage bolts, 6pc 5/16" washers, 6pc 1/4" washers and 6pc 1/4" nuts as shown above. Ensure rounded head of carriage bolt is on outside of building.